Bas Moteur WR200 ?

[Mr.Wheely]

Salut,

I would like to know if the WR Bas Moteur fits in the DT125? I only know that I can use the 125 Bas Moteur with the Vilebrequin of the DT200 for the WR cylinder, but I would like to assemble the complete Moteur of the WR (Cylinder, BAS Moteur, cdi)

Thanks
regards from Allemagne
Michael

[arno]

you can use the crankcase of dt 125 with the crankshaft of dt 200,but the diameter of crank mass of 200 is bigger than 125.It's the only difference
So,you must do ajusted in the crankcase of dt 125 (about 2mm)
you can use the wr cylinder.

[Mr.Wheely]

Hi, I already know that. I want to use the complete WR engine, not only the Cylinder. Does the WR engine fit in the DT125 frame?

[kristian]

http://yam2stroke.fr/viewtopic.php?f=14&t=10290I think tou get the answer... but it's to be checked.....